Tag Archive for 'Siemens'

vorneweg noch zwei Links:
siemens.at/bluetooth/
blue2net.dyndns.org/

Log:
PPCBoot 1.0.1.5 (Feb  7 2002 – 16:32:24)

Initializing…
  CPU:   XPC850xxZTB at 48 MHz: 2 kB I-Cache 1 kB D-Cache
  Board: ### No HW ID – assuming ETX_094
  HW-Version: V0.9 / W50037-Q1-D6-1
  RSR: 0xc0000000
  DRAM:  16 MB
  FLASH:  2 MB
  In:    serial
  Out:   serial
  Err:   serial

Hit any key to stop autoboot:  0
=> help
go      – start application at address ‘addr’
run     – run commands in an environment variable
bootm   – boot application image from memory
bootp   – boot image via network using BootP/TFTP protocol
tftpboot- boot image via network using TFTP protocol
               and env variables ipaddr and serverip
rarpboot- boot image via network using RARP/TFTP protocol
bootd   – boot default, i.e., run ‘bootcmd’
loads   – load S-Record file over serial line
loadb   – load binary file over serial line (kermit mode)
md      – memory display
mm      – memory modify (auto-incrementing)
nm      – memory modify (constant address)
mw      – memory write (fill)
cp      – memory copy
cmp     – memory compare
crc32   – checksum calculation
base    – print or set address offset
printenv- print environment variables
setenv  – set environment variables
saveenv – save environment variables to persistent storage
protect – enable or disable FLASH write protection
erase   – erase FLASH memory
flinfo  – print FLASH memory information
bdinfo  – print Board Info structure
iminfo  – print header information for application image
coninfo – print console devices and informations
loop    – infinite loop on address range
mtest   – simple RAM test
bost    – BOST-tests [? or testnumber]
icache  – enable or disable instruction cache
dcache  – enable or disable data cache
reset   – Perform RESET of the CPU
echo    – echo args to console
version – print monitor version
help    – print online help
?       – alias for ‘help’
=>

ERSTER!